Tool To Remove Carpet Tack Strips

Gently tap the painter s tool with the hammer until it is underneath the carpet tack strip.

Tool to remove carpet tack strips.

Find carpet tools accessories at lowe s today. Cut carpet into haul able pieces. Keep both hands on the knife to avoid cutting a free hand. Remove worn carpet pad and tack strips.

At those points slide a pry bar under the tack strip. The average hourly rate is 60 per hour so expect to pay 180 in total for a contractor to remove and dispose of 12 by. To detach the carpet from the tack strip that holds the carpet in place along walls start in a corner. Slide the pry bar down to the next nail and repeat until the strip is loose from the floor.

Detach carpet from tack strip and adjacent surfaces. Blue hawk 1 in blue tack strip. Then tap it with a hammer until the tack strip pops up. This equals 48 to 72 per hour because it usually takes 3 hours to remove carpet from a 12 by 12 foot room including extracting the tack strips and staples.

Roll up the strips and tape them for easy handling. Removing old carpeting may be necessary to save labor costs if you are having your carpet replaced. Fold the carpet over for easy cutting and slice it into narrow strips. This will create a small space between the carpet tack strip and the floor.

Wear gloves to protect your hands from becoming injured on the sharp tacks. For pricing and availability. Includes planning equipment and material acquisition area preparation and protection setup and cleanup. Safety glasses will protect your eyes in case a piece of the tack strip breaks and becomes airborne.

Use the 6 in 1 painter s tool and a hammer to lift one end of one of the strips. Marshalltown 4 in x 11 in traditional carpet seaming iron. Once the carpet is removed locate the nails which attach the tack strips to the floor. You ve pulled the carpet up in your living room and you re delighted to find the original hardwood floor beneath.

Remove all debris from home and dispose of legally. Press the pry bar in order to begin lifting the tack strip. Then grab the carpet by hand and continue to pull it up along an entire wall. Continue pulling up carpet a few feet at a time and cutting it into easy to handle strips.

The problem you face is the tack strips that were used to install the carpeting. Just grab the carpet with pliers and pull. Roll or fold the strip secure with duct tape and remove it from the room. The floor itself is in great condition.